Every ton of silicon produced leads to emissions of around 5 tons of CO₂.
Carbon capture offers a possible solution to eliminate this emission, but the CO₂ concentration in the off-gas from the furnaces is often too low for CO₂ capture to be cost-effective.
One possible solution to reduce the cost is to increase the CO₂ concentration by recirculating the off-gas. The silicon manufacturer Elkem has collaborated with NTNU and SINTEF to test this idea in a pilot project.
Ambitions for carbon neutral production
Silicon production is an important industry for Norway. Silicon is used in electronics, solar cells, the polymer silicone and as an alloying element in cast alloys. Silicon is produced using what is called carbothermal reduction of quartz. This process involves relatively large CO₂ emissions.
Elkem would like attain carbon-neutral metal production and is working on several initiatives to reduce their climate footprint. Energy recovery, increased use of biocarbon materials and improved material yield are all part of this effort.
Finding solutions related to the capture of CO₂ from the smelters is another challenge that researchers are tackling.
Elkem has conducted an initial carbon capture study supported by the CLIMIT program. The company studied two different capture technologies in collaboration with Aker Carbon Capture and Saipem, respectively. Norsk Energi has contributed to assessing optimal solutions for energy supply and recovery.
Testing known technology in a new field
One of the challenges with carbon capture from smelters is that the CO₂ concentration in the off-gas is low, typically only a few percent, which makes establishing an integrated carbon capture plant more expensive and technically challenging.
As a possible measure to increase the CO₂ concentration in the off-gas, Elkem and researchers at NTNU and SINTEF are investigating off-gas recirculating as a possible way to improve the process.
The CO₂ concentration in the off-gas is increased by replacing some of the fresh air normally supplied to the furnace with recirculated off-gas that is cleaned of dust and cooled.
This is a well-known technology for NOx reduction in incinerators, but the method has not been tested for silicon melting furnaces.
Pilot experiment a broad collaboration
In order to assess the effects of recirculating CO2 on the furnace process, a pilot experiment to recirculate the off-gas was carried out in NTNU and SINTEF’s pilot laboratories at Gløshaugen in Trondheim.
A unique recirculating plant was built here around an existing 160 kW single-phase smelter. The furnace was set up with a number of instruments and analysis equipment to obtain as much information as possible on the effect of the recirculating experiment and to extract knowledge related to the impact on other products and emissions from the furnace.
The pilot experiment was carried out through a collaboration between Elkem projects Elkem CCS, Elkem Sinoco2 and the two NTNU/SINTEF-led centers FME HighEff and the NTNU Center for Research Based Innovation, SFI Metal Production.
Different recirculating rates were tested and mapped through an 80-hour test run.
Elkem provided skilled operators from Elkem Thamshavn as well as raw materials, and SINTEF and NTNU oversaw control of the furnace and the measurement of off-gases.
Sharply increased CO₂ concentration
By increasing the proportion of recirculated gas, we achieved CO₂ concentrations of over 20 percent and also observed lower NOx production.
A lot of data analysis remains to interpret the results, but the experiments show that gas recirculation has great potential for reducing NOx emissions and making CO₂ capture easier for the silicon production process.
The unique infrastructure that has been built up in Trondheim will also prove valuable for future trials and projects with the purpose of contributing to sustainable metal production in Norway and globally.
Recirculating off-gas contributes to carbon capture (2021, July 22)
retrieved 24 July 2021
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no
part may be reproduced without the written permission. The content is provided for information purposes only.